[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
4k wheel bearings...
I give up: For almost a week, I've (unsuccessfully) tried to pull the inner
bearing race off of the spindle using various gear pullers ... none of them
have worked. They all slip out of the little notches before the race moves
and even using a giant C-clamp to hold the arms in place hasn't worked.
At this point, the only practical alternative I can see is cutting them off
with a die-grinder but I'm concerned about nicking the spindles ... putting
them in a lathe to cut them off isn't an option nor is buying a new pair of
Anyone have a better idea?
/ l l o l \ l o AudiDudi@delphi.com
/__l l l / l l = l l l l / l l Jeffrey Goggin
/ l l_l \_l l l__/ l_l \_l l Scottsdale, Arizona