[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

'86 4kcsq E-brake lever on rear caliper

 The subject line says most of it.  I replaced the dust boots and seals
on both rear brake calipers (one dust boot was ripped up pretty good from
a prior brake job).  The other caliper still had a good dust boot on it,
but since the kit came with boots/seals for both I did this one as well.
Problem is the E-brake lever on this one is very stiff (the other one
springs back nicely).  Is there any maintenance that can be done to free
it up, or am I looking at buying a reconditioned caliper? 
 Direct replies would be appreciated (digest member).

Dan Cooke
'86 4kcsq