[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: Replcing tie rod assmby. on 80...
When I replaced my outer tie rod ends I rented a puller from rental city
for ~$5. They were actually quite easy to get out, in my opinion they
could be tapped out.
On Tue, 12 Mar 1996, Mark Shilling wrote:
> Hey Guys!
> This weekend I am going to replace the left tie rod assembly and ball joint,
> hopefully fixing the clunking and creaking that I am getting since
> discovering the end nut is *warped*. (Originally frozen/overtorqued, now
> apparently loose) in place The procedure (for the tie rod) calls for either
> a press or a puller to complete the job. Since I have neither are there any
> *common household substitutes* I can use? Any help is greatly appreciated!
> Mark A. Shilling V.(512) 477-4465
> Texas Chemical Council F. (512) 477-5387
> 1402 Nueces email@example.com
> Austin, Texas 78701 www.txchemcouncil.com