rear lenses-aaaauughhh!

[brettd@tiac.net (Brett Dikeman)]

It seems that water has accumulated in the driver's side stop/turn signal
lense.  Followed the Bently's instructions, but the damn thing wouldn't
budge an inch after all the nuts were off+lamp holder was out.  Is it the
seal they show in the bad diagram?  It looked to be non-adhesive, but the
stuff on the car looks like it's shaped around some funny looking fins at
the top of the plastic.  My guess is it's caulking, in which case I don't
really want to pull it off-or do I just have to give the sucker a good hard
tug to get it out, no caulking?  The Bently's diagram had no directionsd
other than "remove four nuts".  Very useful.  Hmph.  My favorite part was
when the diagram on the page before referenced itself as where the
instructions were.  I hate stupid circular references...


Oh well...

Brett