Re: Starting (mixed plug wires)

[Huw Powell <human@nh.ultranet.com>]

> Is there an easy way to tell/know which ones go where?  I guess one
> could use the firing order to figure which ones should get spark
> sequentially as the rotor spins.

I think the haynes cheapo manual has a diagram - would have expected it
to be in Bentley..  Putting the wires on in firing order unfortunately
doesn't tell you where to start.  So you would have to trun the engine
to TDC, hope it the right one (pre-ignition, not pre-intake) and check
the rotor position.  Whew!  I think usually the rule is to
remove/replace one wire at a time?  Or as on my Frod truck, write the
cylinder numbers on the cap with permanent magic marker?

-- 
Huw Powell
HUMAN Speakers

http://www.thebook.com/human-speakers

ignorance is only as powerful as the desire for bliss...