[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Wheel Bearing

Hi everyone, I have a wheel bearing problem on my 89 Audi-90Q so I intend to get
to it this weekend.     Unfortunately I do not have a manual.  I have replaced the
front wheel bearings before, but I have not replace a rear bearing as of yet.  

My question is this: Since I don't have a manual I am not sure how to go about
taking off the trim, that is the back seat, the rear window sill ? etc., etc.  to get to
the top strut nut.   Do I have to take anything off at all ??  or can I get to it without
taking the trim off??

Is there anything I should watch out for at the bottom end??  Your help is greatly
appreciated.  Thanks very much.

Tony .   89 Audi model 90/Q