[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Programmer springs

I just swapped my programmer for a new on I had in my old 5ks. It was a
while I was at it type thing. Nothing wrong with the old. The newer one
had a spring on the arm that pulls toward the heat side. The old one
didn't. Same part #'s. What's the deal? I also noticed that at the heater
box end, there was a sping that pulls toward the cold side that was
disconnected. What the deal? I reconnected it, but the programmer arm
doesn't pull all the way toward heat, so I'm going to disconnect the box

'84  5ksT 1.6-2.0 bar

Disclaimer:"Any information contained herein is based purely on my own
personal experience and may not necessarily reflect yours. Use caution as
your results may vary from mine."