[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

RE: Rear control arm and front fender help please

A fellow I work with buys Craftsman tools from Sears, cuts/grinds/welds/modifies and then returns for a replacement if he thinks he will never use the customized tool again. They take them back and replace them without question!


Buy a 17 mm box-end wrench at a pawn shop for $1. Add a little
"acetelyne offset." Grind the open end down to ~1/8" thickness. The
handy small-car-LCA/fuel-pump-fitting wrench.

not as high-tech as Igor, but watch out!
'87 4kq
'89 200q