[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: hydraulic pump

You have to have the pulley hub (sort of triangular part the pulley
bolts to) pressed off the shaft. Replace seal and then have it pressed
back on. To press it on, the pump has to have the rear half removed to
expose the back end of the axle to press against. Follow Bentley
procedures like marking pump halves before disassembly etc.
P.S. I got the seal kit from Blau for about $20.

Mike Mulholland wrote:
> hi wolff, is the shaft seal you replaced the one just behind the drive
> pulley? if so could you tell me how to do the job. thats the one that failed
> on mine.
> thanks
> mike
> 86 5kcdtq
> 84 5ksw
> 84 5ks