90q TB 2084 doesn't fit ?????

[Andrei Kogan <abk@phy.duke.edu>]

Hello,

I know it sounds stupid, but...

I am halfway into my timing belt job. Everything was going well, until I
got stuck with this prtoblem:

There is a rubber stopper/cap/plug on the harmonic balancer  which  covers
precisely the section where   the fork end of the 2084 wants to go. It
would have worked just fine if the fork on the 2084 was positioned further
towards the engine, maybe 3/4" or so. Do I have a phony 2084, or should
that cap come off? It looks like the only way to take it of is forward, and
there isn't enough space there for that, I don't think.

Also, once I am in the stupid question mode, could someone tell me -- is
that bolt 29 mm? Sears in DUrham doesn't have any 6 point metric sockets
bigger than 21 mm, and I am trying to figure if I can use one of the
standard ones instead.  I am reluctant to try a 12 pt socket. If anybody
used those and can confirm that it's OK for the bolt, please let me know.

Somehow the 4k Bentley isn't much help, I am buying the 90q Bentley as soon
as I am done with this !
Andrei