HELP! Window won't go up!

[Daniel Hussey <GY3WSX@vm.sc.edu>]

   Thanks to all who responded on this post!

   I did the regulator test as outlined in the bentley manual.  The power wire
going to the switch for up was bad (no voltage).  So, given a few hints from
listers, I followed this wire all the way into the door jam and sure enuough...
It was broken in half!  This was the culprit.  I put in a crimp connector and
it works now.  Window goes up and down.

   BTW, Any of you with an older Audi should check this area.  I had this one
wire which was completely broken, and a few others that look like they are
about to go.  The sheathing is broken on a few already, and I need to go back
in there and eventuallt solder in new pieces and heat shrink.  This looks like
a common weakpoint in the Audis (at least the type 44's).

   Thanks again for all those who responded.  It cost me $0.43 and a little
bit of time to fix versus me jumping to conclusions and ordering a new window
regulator.  Thanks again!

   Later,
   Dan