[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Extrude Hone on an Intake Manifold?

In a message dated 8/31/99 8:03:31 PM Eastern Daylight Time, 
mswanson@cisunix.unh.edu writes:

<< Prices seemed steep.  They
 ranged from $200-800!!  Anybody done this to an intake manifold??  Is it
 worth it? >>

    I called not too long ago, they wanted about $550!!!  Definitely not 
worth it in my opinion, especially since there are listers out there with 
over 300hp from their MC running the stock IM...