[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: CIS injector fun...

JShadzi@aol.com wrote:
>     I pulled some injectors today to replace the rubber seals.  I used the
> little L shaped tool with a piece of plywood on the valve cover and a good
> sized pry bar.  The first 4 came out OK, but the last one was a doozy.  The
> pry bar slipped off the injector several times sending the tool 30 feet in
> the air, and once bouncing off the roof...missed the gutter somehow!  I must
> have had my 160 lbs on the end of that pry bar, about 18" long;  those old
> o-rings were hard as rocks!

and that fifth injector is a bear to get to (as I recall the CSV is
usually right in the way of the tool).  Hope you didn't injure your car,
yourself, or innocent passersby...

Huw Powell


82 Audi Coupe; 84 4kq; 85 Coupe GT; 73 F250