[200q20v] Correct distributor rotor?

Mike O'Donnell mod2000 at home.com
Thu Aug 17 18:35:04 EDT 2000

Myself and a few other folks in the area are also "glueless in Seattle" (bad
humor; couldn't resist).  I think Audi's concern is the possibility the
rotor could work its way off the shaft due to the angle of the distributor.
When I recently replaced my rotor, the fit was so tight it seemed
unnecessary.  Anyone had any problems?

Mike O.

----- Original Message -----
From: Glen Dustin Powell <gpowell at ennovatenetworks.com>
To: <C1J1Miller at aol.com>; <william.kessell at worldnet.att.net>
Cc: <200q20v at audifans.com>
Sent: Thursday, August 17, 2000 2:14 PM
Subject: RE: [200q20v] Correct distributor rotor?

> I have never glued the replacement rotors on, no problems so far.... I've
> used only the correct 200q20v rotors sourced from Rod @ TPC. Others I know
> also use no glue with no known problems.
> -glen
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v

More information about the 200q20v mailing list