[200q20v] Correct distributor rotor?
Glen Dustin Powell
gpowell at ennovatenetworks.com
Fri Aug 18 09:42:30 EDT 2000
It also has the distributior cap to hold it in place.
From: 200q20v-admin at audifans.com [mailto:200q20v-admin at audifans.com]On
Behalf Of C1J1Miller at aol.com
Sent: Thursday, August 17, 2000 9:37 PM
To: mod2000 at home.com; gpowell at ennovatenetworks.com;
william.kessell at worldnet.att.net
Cc: 200q20v at audifans.com
Subject: Re: [200q20v] Correct distributor rotor?
In a message dated 8/17/00 8:51:57 PM Eastern Daylight Time,
mod2000 at home.com
> Myself and a few other folks in the area are also "glueless in Seattle"
> humor; couldn't resist). I think Audi's concern is the possibility the
> rotor could work its way off the shaft due to the angle of the
> When I recently replaced my rotor, the fit was so tight it seemed
> unnecessary. Anyone had any problems?
> Mike O.
Well, it is subject to some severe heat cycling, vibration, and is mounted
horizontally for an average of about 100,000 miles...
200q20v mailing list
200q20v at audifans.com
More information about the 200q20v