[200q20v] Correct distributor rotor?

C1J1Miller at aol.com C1J1Miller at aol.com
Fri Aug 18 10:57:05 EDT 2000

In a message dated Fri, 18 Aug 2000  8:42:18 AM Eastern Daylight Time, "Glen Dustin Powell" <gpowell at ennovatenetworks.com> writes:

It also has the distributior cap to hold it in place.



Very true; small spring-loaded contact centered on the rotor.  When I pulled my (non audi) distributor cap off, the center post of the cap was mostly worn away, and the center of the rotor was pretty burned up but still working.
The glue procedure is pretty simple, and documented in the bosch guidance... as I recall, clean shaft, spray with a primer/cleaner, add some form of loctite, put on the rotor, let dry.

More information about the 200q20v mailing list