[200q20v] Bose amps going bad...
b.m.benz at prodigy.net
Sat Aug 4 23:13:54 EDT 2001
Taking a few liberties, I'd take Chris's option of a face up in the trunk
with a case of beer any day, over your alternative of "face down from above,
requiring many, many partial turns of a 10m wench to remove the nuts holding
each spanker". But then, I'd give up beer for a loving wench!
'90 90Q-20V 140K
'91 200Q-20V 140K
Ford "Quatro" Tractor
Other Misc. Toys
> From: Phil Rose <pjrose at frontiernet.net>
> Date: Sat, 4 Aug 2001 19:46:50 -0400
> To: C1J1Miller at aol.com
> Cc: digitaleopard at hotmail.com, 200q20v at audifans.com
> Subject: Re: [200q20v] Bose amps going bad...
> At 7:06 PM -0400 8/4/01, C1J1Miller at aol.com wrote:
>> In a message dated 8/4/01 4:50:20 PM Eastern Daylight Time,
>> digitaleopard at hotmail.com writes:
>>> 2) Chris Miller's site makes replacing these sound like a MAJOR headache;
>>> has anyone found a less painful way to do it?
>>> 3) The front speakers were starting to work intermittantly, as well; is
>>> likely a variation on the same problem, or just a loose wire?
>> Replacing the rear speakers is not a major job, just kind of tedious, laying
>> face up in the trunk.
> For an alternative sort of tedium, the job _can_ be done from above.
> It requires many, many partial turns of a 10 mm (or was it 8 mm?)
> wrench to remove the 4 nuts holding each speaker. A normal 1/4" drive
> socket will not fit. If doing it again I'd buy one of those box-end
> ratchet wrenches--possibly the offset kind. This would make the job
> relatively easy, IMO.
> But when you're all finished, have you just installed somebody
> else's old Bose speakers--with the same possibility of combustion? :-(
> Phil Rose Rochester, NY
> '91 200q mailto:pjrose at frontiernet.net
> 200q20v mailing list
> 200q20v at audifans.com
More information about the 200q20v