[200q20v] Low boost (1.7) and Hesitation under load (4000 rpm+)
vegener at post7.tele.dk
Tue Aug 28 10:40:55 EDT 2001
The standard 200 20V have a 2.0 Bar boost sensor and
1.7 - 1.8 is normal readings for that.
The IA stage 3 and many other, have a 2.5 Bar boost sensor.
A 2 Bar boost sensor gives a electrical output signal to the ECU
(and the built in dash display) of 5.0 Voltage for 2 Bar of abs. boost.
A 2.5 bar gives a 5.0 Volt for 2.5 Bar abs
And a 3 Bar 5.0 Volt for 3.0 Bar abs. etc.
If the ECU is chipped with another boost sensor, the readout
have to be ree-calculated - or mount a mecanical gauge!
200 q 20V Avant
(IA Stage V 3 Bar)
----- Original Message -----
From: "Noelle Beaudin" <nobeau at tcnow.com>
To: "Kneale Brownson" <knotnook at traverse.com>
Cc: <200q20v at audifans.com>
Sent: Tuesday, August 28, 2001 3:21 AM
Subject: Re: [200q20v] Low boost (1.7) and Hesitation under load (4000 rpm+)
> >Kneale wrote:
> >1.7 is stock. I assumed with his posting that he had a chip/mod.
> >Otherwise he's been running overboost.
> I've got a chipped 2ctq20v avant with the exact same problems as
> described by Shawn. I personally have never even seen the car reach
> 1.7 or above. The upgrade is an IA Stage 3 that was done in 1998.
> When I talked to Ned from IA he suggested that the hose that runs
> behind the heat shield by the wastegate could have burned through and
> that I replace it. Of course, not that I've done this yet to see if
> it makes any difference. However, I did notice that there is a new
> O2 sensor that was patched in (I just bought this car 6 weeks
> ago)...so - as with Shawn's example I am now wondering if this could
> be the problem, or part of the problem as well. Any help for both
> Shawn and now me would be great.
> '86 5ktq
> '91 2ctq20v
> 200q20v mailing list
> 200q20v at audifans.com
More information about the 200q20v