[200q20v] Tranny Replacement

Phil Rose pjrose at frontiernet.net
Tue Feb 20 10:00:54 EST 2001

At 9:14 PM -0700 2/19/01, Mike Miller wrote:
>The way I checked my tranny mounts is as follows:
>Lift throttle in any gear - if the shifter moves, the rear mounts 
>are likely bad. After I replaced mine, the was NO movement of the 
>shofter on lifting the throttle.
>mike miller

I have tried to check for shifter movement. While I thought I could 
_feel_ some slight movement, it's hard to say it's enough  to 
actually be seen. Is _any_ amount of movement "too much" (i.e., 
enough to warrant mount replacement)?   I'll check again--I suppose 
there could be as much as 1/8" movement under some conditions. That 
doesn't seem very bad, to me, but...?


Phil Rose
Rochester, NY
mailto:pjrose at frontiernet.net

More information about the 200q20v mailing list