[200q20v] 200-20V Injector O-ring seals.

Bernie Benz b.m.benz at prodigy.net
Fri Jan 12 18:44:35 EST 2001

Hi Chris,

FYI and website, I have sized generic O-rings for the subject injectors.
Two each required for each injector, O-ring size: #2-203, material: Viton.
Cost, about $.50 each.  Audi list: $3.00 each.

Apparently, Audi also shows a seal for the plastic insert that screws into
the manifold to locate the injector nozzle.  If mine had had these seals
installed, they had desolved, as there was no solid material remaining where
an O-ring might go.  Selecting an O-ring for this is also a simple task now
that I have the inserts removed. So, I'll go do it and be right back.
A #2-016 Viton O-ring would be correct.  One required per injector insert.
The Viton material is not affected by hot fuel.

Regards,  Bernie   

> From: C1J1Miller at aol.com
> Date: Thu, 11 Jan 2001 22:02:55 EST
> To: wolff at turboquattro.com, 200q20v at audifans.com
> Subject: Re: [200q20v] Fwd: Re: [s-cars] fuelishness
> In a message dated 1/11/01 9:50:42 PM Eastern Standard Time,
> wolff at turboquattro.com writes:
>> FYI,
>> Mine is a leaker. I'll try to get a pic of the place it's leaking from so
> we
>> can see if it's the same for everyone.
>> Wolff
> Here's links to a pic of fuel lines on the 200q20v.
> http://members.aol.com/c1j1miller/p-steer-hose-rem.jpg
> chris
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v

More information about the 200q20v mailing list