[200q20v] re: voice activated phone fs

C1J1Miller at aol.com C1J1Miller at aol.com
Fri Mar 23 07:33:23 EST 2001

Well, what's considered a lot of work?
You need an antenna installed, a pass-through on the glass (glue-on) would work.
You need the "brain", that's included, and mounts on the frame rail in the trunk.  You need the wiring harness; I'll include that from the phone to the console.
You need a microphone and speaker; might be better to get that after market?
So, pretty easy overall; no more involved than any installation process for an installed phone.

In a message dated Thu, 22 Mar 2001  2:17:58 PM Eastern Standard Time, Brett Dikeman <brett at brettd.dsl.speakeasy.net> writes:

<< Isn't it quite a bit of work to install it in a car not equipped with it
previously?  Completely ignorant here on that subject...


On Thu, 22 Mar 2001 C1J1Miller at aol.com wrote:

> I've recently switched to a hand-held phone since I'm constantly switching 
> between two cars.  I'm considering selling my Audi hands-free voice activated 
> analog (Motorolla) phone from my '91 200q20v. Any interest?  The phone is 
> very nice, and can be programmed to recognize two separate voices for 
> commands.
> Chris Miller, Windham NH, c1j1miller at aol.com
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v


More information about the 200q20v mailing list