[200q20v] (no subject)

Derek Pulvino dbpulvino at hotmail.com
Sun May 6 11:32:42 EDT 2001

I believe I've seen this one on my car before.  Came up what seemed to be 
errantly.  Sounds like your checking faults with the car running; in my case 
finally figured out that it was occuring because I was checking fault codes 
with the car not running.  Doh!

Derek P

Message: 2
From: C1J1Miller at aol.com
Date: Fri, 04 May 2001 12:55:34 EDT
Subject: Re: [200q20v] Fault Code 2112
To: <pwpetersen at earthlink.net>
Cc: <200q20v at audifans.com>

Timing (62 degrees BTDC) reference sensor
Flywheel pin damaged/missing,
Mis-located Sensor, flywheel pin, distributor hall sensor out of adjustment"

Distributor out of alignment?  Did you just do a new distributor, or a 
belt? Try rotating the distributor slightly.

Could also be a dirty/damaged reference sensor.

In a message dated Fri, 4 May 2001 12:09:03 PM Eastern Daylight Time, "Peter
Petersen" <pwpetersen at earthlink.net> writes:

<< Anyone have experience with fault code 2112.  According to the SJM 
library, if the sensor fails, the car will not restart.  I've cleared the
codes, restarted the engine and get 2112 again.  Just happened last night so
I haven't had a chance to check the manual but I'm hoping someone has a
simple solution to this.



Get your FREE download of MSN Explorer at http://explorer.msn.com

More information about the 200q20v mailing list