[200q20v] Distributorless ignition?
tommy.arnberg at nokia.com
tommy.arnberg at nokia.com
Thu May 24 12:45:41 EDT 2001
Here are the dedicated www-pages for
5 coil direct ignition system for A200 20V 3B / S2 3B
The UMBAU "should" be ready this summer.
Time has been limited.
It is not cost effective = true hobby
with many technical challenges,
but the only way to build Audi RS200 20V
with original electronic cabeling with "minor"
mods ...(which reminds something like -86 Talladega)
Lately I have been doing the Cruise control
mods for the carrier plate and planning the
fuel line mods. Otherwise engine is allmost
ready for installation. RS2 Turbo needs general
service round with new gaskets and some extra.
Final electronic system test
in current 3B with separate 5 x coils is
pending and shall be done very soon with
propper connections and end ignition
stage cooling plates.
There are several mechanical ways to do the coil system.
closest 3B Manifold system here
- it is "easiest" way to do with ABY parts
+358-50-555 55 75 (if questions)
- remeber the time difference
PS. It is not distributorless ignition because
the system needs 3B distributor for acting as
a AAN Hall sending unit (very early -91 A100 S4
AANs were like that from factory)
> -----Original Message-----
> From: ext Peter Schulz [mailto:peschulz at cisco.com]
> Sent: 24. May 2001 0:12
> To: 200q20v
> Cc: tommy.arnberg at nokia.com
> Subject: Re: [200q20v] Distributorless ignition?
> Actually, it HAS been discussed here and on the S-Car list,
> by Tommy Arnberg...
> check out :
> maybe Tommy can give us his status.
> Peter Schulz
> 1990 CQ
> 1991 200 20v TQW
> Chelmsford, MA USA
> peschulz at cisco.com
> At 03:47 PM 5/23/2001 -0400, you wrote:
> >On Wed, 23 May 2001, Archibald, Jon wrote:
> > > I imagine this has been discussed many times before, but
> I could not get a
> > > definitive answer from the archives, so please forgive
> me, I'm new. Here
> > > goes:
> > >
> > > Is there any cost-effective way to upgrade the 3B motor
> to distributorless
> > > ignition? Can the S4/S6 AAN igntion system be made to
> work with a 3B?
> >Actually..I don't think it has been discussed. I've
> wondered myself, but
> >I came to the conclusion that there were far better things
> to improve on
> >than the ignition system(like the manifolds, head work, better
> >intercooler, different turbo, etc.)
> >Most people don't bother to the extent that they have the RS2 intake
> >manifold machined to clear the 3B distributor...
> >200q20v mailing list
> >200q20v at audifans.com
> Peter C. Schulz peschulz at cisco.com
> Quality Systems Engineer/SSE http://www.cisco.com
> Customer Contact Business Unit (CCBU) Direct: 978.275.7772
> Cisco Systems, Inc. Fax: 978.275.5299
> 900 Chelmsford Street Pager: 800.365.4578
> Lowell, MA 01851 USA
More information about the 200q20v