[urq] Re: [200q20v] DIY Alignment, was front
suspension/replace tie rods
b.m.benz at prodigy.net
Thu May 31 22:22:11 EDT 2001
What do you want? Tools were listed. In addition you need a relatively
flat, doesn't have to be perfect, garage floor. The rest is considered
logic and patience. Ask specifics.
> From: Wolff <wolff at turboquattro.com>
> Date: Thu, 31 May 2001 18:52:06 -0700
> To: urq at audifans.com
> Subject: [urq] Re: [200q20v] DIY Alignment, was front suspension/replace tie
> Fellows, let's really get some details here, 'cause I have tried all the
> local shops with no luck. Last shop left my camber full neg on one side and
> full pos on the other! I should have tried to align it myself to start with.
> It drove fine before, but I had a worn out tie rod end, so I replaced it.
> Now after several alignments it wanders and has very poor turn in? It's like
> the rear of the car takes a second to decide to follow the front.
> "Nobody can forget the sound." - Michele Mouton
> ----- Original Message -----
> From: Bernie Benz <b.m.benz at prodigy.net>
> To: <ikessel at amexol.net>
> Cc: 200q20V mailing list <200q20v at audifans.com>; audi-20v
> <audi20v at rennlist.org>
> Sent: Thursday, May 31, 2001 4:00 PM
> Subject: [200q20v] DIY Alignment, was front suspension/replace tie rods
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
More information about the 200q20v