200-20V w/ V8 front anti roll bar.
charlie at istari.com
Fri Dec 13 17:39:24 EST 2002
OK, so I keep spacing out the need to pass this on:
> -----Original Message-----
> From: Ed Kellock [mailto:ekellock at juno.com]
> Sent: Thursday, December 12, 2002 8:45 PM
> To: 200q20v at audifans.com
> Subject: Re: 200-20V w/ V8 front anti roll bar.
> Mike Pederson on the S-car list has figured out the rear sway bar
> retrofit. Check the S-car archives for the write-up or his
> email address
> (mlped at somethingsomewhere.com) .
I contacted Mike yesterday about his rear mounts, his response:
> Back when I had the original batch of adapters done up, I traded several
> emails, along with information on the adapters with Berni Benz on the 200
> list. At the risk of miss quoting him, I think his conclusion was "It ought
> to work ...." but I never heard of any interest from any of the 200TQ'rs.
> If there is an interest, I have a set of adapters that I held in reserve for
> personal use. I lent my 17mm RSB to Hap to send off as a pattern, but I
> think I should have it back sometime fairly soon.
> It some one has a 200TQ in the Denver area to volunteer as a test mule, it
> doesn't take much more than about 30 - 50 minutes to fit one of these up to
> a car to see if it fits. If you know of someone that's interested, have
> them give me a call.
> On the supply side, more can be made up if there is an interest. I've cc'd
> Hap on this so he'll be up to speed if you decide to contact him
Bernie we all know and love to bug...
Hap is a Hawaiin-shirt-wearing urS4 wildman who has worked out a rear
the later urS4s, many of us who frequent both lists know the legend...
I'm in the Denver(Boulder) area, usually have no time to play but may be
to provide both sedan and avant test mules. Somebody please weigh in on
to quantify the difference in handling with and without the added bar as
think a subjective butt-dyno is adequate. (G-Tek... toy or tool??)
More information about the 200q20v