Subject: Experience Passenger side Engine mount R&R?
gene.ghc at verizon.net
Mon Jun 17 10:48:44 EDT 2002
C1J1Miller at aol.com wrote:
>Peter: been a while, but as I recall:
>Start off by removing the little heat shield; it 's in the way and you'll spend a lot of time trying to work around it when it comes out pretty easy. The little screws might strip...
>Wasn't much more than unbolt it, pull it out, put in the new one. Think I supported the engine from below with a jack, and make sure you put the heat shielding and vent hose back the same way.
>Subject: Experience Passenger side Engine mount R&R?
> Can someone who has replaced their passenger side mount with removing the
> turbo or manifold share their experience?
> Peter Schulz
>200q20v mailing list
>200q20v at audifans.com
Similar to Chris's comments, but also had to lower the subframe about 1
inch to make room to get mount in/out. Did not completely remove
subframe bolts though.
More information about the 200q20v