output tests using vag-com
dans at audifans.com
Tue May 7 21:02:26 EDT 2002
I got this reply from Ross-Tech. Has anyone tested it on the 200?
VAG-COM can perform output tests on vehicle that support them. See this
QSHIPQ at aol.com wrote:
> [ Picked text/plain from multipart/alternative ]
> To be more specific, the early motronic found in the 91 200 is not supported
> by aftermarket 1552 in terms of output test procedures. You should get a
> "this function not supported" message, dan. You can get stored fault codes,
> but you cannot do output tests with most of these tools.
> Scott Justusson
> In a message dated 5/7/02 11:29:08 AM Central Daylight Time,
> rbwinchell at yahoo.com writes:
> You can use VAG-COM with the 2 prong adapter. You
> connect to the 2 connectors on the left (not the far
> right one).
> Block 0 is the only data block supported by the 3B
> engine. There are 10 values, which are listed in the
> Rob Winchell
> 200q20v mailing list
> 200q20v at audifans.com
More information about the 200q20v