Stuck rear calipers [redux]

davidb01 davidb01 at
Fri Oct 11 11:52:29 EDT 2002

Didn't notice there's only one 2-pin adaptor in the bottom illustration.
That's the one I have.  Contact them for the p/n, since not enough info in

 -----Original Message-----
From: 	200q20v-admin at [mailto:200q20v-admin at]  On
Behalf Of davidb01
Sent:	Friday, October 11, 2002 10:07 AM
To:	200q20v at
Subject:	RE: Stuck rear calipers

There's also Lisle Tool Corp; see

* Specifically, "Rear Disc Brake Piston Tool (28300)" (cube-type); also the
piston tools illustrated on the very bottom of this same page.  I purchased
one of these, but don't recall which one.

 -----Original Message-----
From: 	200q20v-admin at [mailto:200q20v-admin at]  On
Behalf Of Kneale Brownson
Sent:	Friday, October 11, 2002 9:55 AM
To:	Jagernauth, Stephen, RTLSL; 200q20v at
Subject:	Re: Stuck rear calipers

I've used a large C-clamp to apply pressure to the piston while turning
with water pump pliers (careful not to pinch the rubber boot with pliers
teeth--guaranteed to cause tears and tears).  Opening the bleeder sometimes
makes compressing with the C-clamp easier.  Usually, if you get it turning,
you can just keep turning.  Can't say enough about how much easier moving
the piston back in is

At 10:52 AM 10/11/2002 -0400, Jagernauth, Stephen, RTLSL wrote:

>Searching the archives, I found little on this subject.  Did a Google
>search on the mother list as well.
>I'm replacing rear rotors/pads since they are down to minimum.  I'm
>changing fluid and fixing stuck e-brake cable/rusted shaft
>as well.   (Just got done with suspension bushings).
>Pistons will not retract at all, I don't have a special tool to fit into
>the piston grooves.  15" Channel Lock is doing nothing.
>Caliper rebuild time?   I can take the calipers off and stick in the vise
>if that will help.  Do I need to crack bleeder valve to
>relieve pressure, never had to do that so I suspect calipers are really
>frozen.   Need to pass inspection so I can get 20V
>back on the road and tuck the 28 year old daily-driver 911 into garage for
>If I have to rebuild calipers, do I need special tool to get them
>out?  Home-brew solution?
>Advice welcome.
>Steve Jagernauth - Easton, PA
>'91 200q20v
>'74 911/3.0 Targa - street
>'74 911/3.2L coupe - track
>'93 GMC Sub - wife's/tow

200q20v mailing list
200q20v at

More information about the 200q20v mailing list