Shift linkage refurbishment
Ingo D. Rautenberg
ingo at waratap.com
Fri Sep 20 15:17:28 EDT 2002
Thanks, Mike, but this has happened since before I replaced the trans mounts
(which were done at the same time as the clutch....hmmm.
----- Original Message -----
From: "Mike Miller" <mikemilr at blackfoot.net>
To: "Ingo D. Rautenberg" <ingo at waratap.com>
Cc: <200q20v at audifans.com>
Sent: Friday, September 20, 2002 12:52 PM
Subject: Re: Shift linkage refurbishment
> ----- Original Message -----
> From: "Ingo D. Rautenberg" <ingo at waratap.com>
> > As mentioned before, I have the same symptom as Phil, except that in my
> > Blue 200q20v sedan (is it the color?) it is only in the forward-throw
> > gears -- I imagine 1,3 & 5; but honestly, I don't keep her in 1st long
> > enough to tell.
> > I, too, can eliminate the noise by pulling up on the shift knob. This is
> > the throwout bearing (BTDT).
> > My shifter is also on the sloppy side.
> > -Ingo
> This sounds like it could be the rear tranny mounts.If the shift lever
> a lot front to back when lifting/applying throttle, I would check them
> mike miller
> helmville mt
> 200q20v mailing list
> 200q20v at audifans.com
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.386 / Virus Database: 218 - Release Date: 9/9/2002
More information about the 200q20v