ignition switch

Peter Schulz peschulz at cisco.com
Wed Apr 30 17:33:44 EDT 2003


Trick is to find the right section in the Bentley manual that tells you where to drill about a 1/8 inch hole so that you can release a spring that holds the cylinder captive in the sleeve.


t 04:08 PM 4/30/2003 -0400, Steve Gronback wrote:
>What is the trick to removing the ignition switch cylinder from the cast
>iron sleave.  My electronic switch was cracked, which caused the failure of
>the ignition, but I want to change the key cylinder while I'm in here, if I
>can figure out how to remove it...
>200q20v mailing list
>200q20v at audifans.com

Peter Schulz
1990 CQ (awaiting S2 3b engine transplant)
1991 200 20v TQW indigo mica
1991 200 20v TQW titanium grey
Chelmsford, MA USA
peschulz at cisco.com

More information about the 200q20v mailing list