Injector Seal Kit, major improvement, minor investment

Peter Petersen pwpetersen at
Wed Aug 20 22:55:51 EDT 2003

This is a multi-part message in MIME format.
[ Picked text/plain from multipart/alternative ]
Hi All:

I just wanted to pass this along.  I recently replaced the injector
o-rings and plastic cap that snaps on the end of the injector (after
150K).  I probably should have had the injectors professionally cleaned
etc but am too cheap.  Anyway, I have noticed a significant improvement
in cold start idle and performance under load is more stable.  The
engine used to have an occasional high load misfire (very light) that I
could never quite resolve.  Also, the occasional stall when coming off
high boost, even after replacing all the usual suspects.

For 25 bucks (from the Audi dealer), it was a big improvement.  If some
of you have high mileage injector o-rings and unexplained “reduced
potential” issues, you may want to give it a try.

I think when cold, the worn o-rings were not sealing properly hence poor
idle and bad exhaust smell.  The smell still isn’t great but is more in
line with a 150K engine.  I think there was another problem under
certain vibrational loads the injectors would leak, resulting in part
and high load misfires.  I was beginning to suspect an ignition problem,
but the engine now runs great.

In the intake manifold, there is a plastic insert the injector slides
into.  I cleaned these out with carb cleaner, q-tips, and a vacuum
cleaner as most of them were stuck in the manifold.  Everything took
about 1.5 hrs.  When snapping the cap on the end of the injector, make
sure not to damage the needle pintle as it is external to the injector.



More information about the 200q20v mailing list