bernie strut brace

Bernie Benz b.benz at
Fri Dec 26 22:39:24 EST 2003

> From: "vinnie basile" <bleaf1 at>
> HI listers I know this question is old and been through the mill,but I
> recently replaced all 6 bushings on the bottom of the car(subframe ,tranny)
> and at the same time I want to correctly install the bernie strut brace.what
> holes do I make a little bigger so that the brace could push outword ,the ones
> in the strut towers themselves or the plates that sit on top of the struts
> that are maxed out allready?
I recomend,k and have elongated the mounting holes in the strut tower to
allow the strut to move outward to the full limit of the tower.


More information about the 200q20v mailing list