heads-up on handbrake cable mislabelling
peschulz at cisco.com
Tue Jun 24 00:21:49 EDT 2003
I did not...I found that the rubber grommets/donuts would still work, using the same body mounts as the blocks.
I just figgered that it was just another audi parts succession or "improvement"
The cable removal/installation was the typical bear (forgot about the clips that hold the cable ends near the threaded shaft under the ebrake lever) - I ended up using a carpenter's cats paw to remove them since I did not have long reach needle nose pliers.
Chris Miller gave Mike Sylvester and Keith Bedard a hand in replacing similar ebrake cables on a 92/93 100 V6 quattro, which was almost as much fun.
At 09:23 PM 6/23/2003 -0400, Phil Rose wrote:
>At 8:27 PM -0400 6/23/03, Peter Schulz wrote:
>>i used the "wrong ones' on de wife's wagon with no ill affects.
>Did you have to transfer that rubber block from your old cables to mount them?
>>At 05:18 PM 6/20/2003 -0400, Phil Rose wrote:
>>>I recently received packages of GEMO (oem) handbrake cables that had
>>>the correct label and p/n (441 609 721B/722B) for the '91 200q20V,
More information about the 200q20v