Make your 20v a 20vt...

CuatroKoop at CuatroKoop at
Thu May 8 01:52:31 EDT 2003

I bet I get a bounce from the 200 list...

Anyway, I'd be willing to do so if I had a 351N head along side the 351B
heads I have (last three digits + suffix of the 3B and 7A heads if you were
wondering).  I checked the fishy to see what the gasket/seals looked like in
hopes that the 351N used a single (joined) gasket for the four ports on the
water manifold.  It doesn't, three o-rings and a triangular gasket.  Having
the manifold itself would be of some benefit, as I could atleast start coding
the CNC machine (lack of origin point however).  Maybe, just maybe, I could
get it positioned correctly on the 351B, or to a point that it would work.
Only problem I can foresee is that of the 351B's single point water manifold.
 It may be in the way and of the wrong diam (too large?) and wrong bolt
pattern.  I guess I could always weld the bolt holes since there'd have to be
drilling and tapping going on anyway.  Not sure what to do if that port is
too large (interference fit alum. sleeve?).

Rambling...sorry...Back to studying for my Fluids final...

-Eric F.

More information about the 200q20v mailing list