Help - The Bomb
dbpulvino at hotmail.com
Thu Sep 4 19:21:02 EDT 2003
To further sully the waters, and at risk of jinxing my work, I reassembled
my pump using Pentosin as a lube for the o-rings, and have not seen leakage
to this point.
It's been at least two-months now...so maybe there's more of a time lag, but
to date this did not present issue in my case.
...thusly maybe Pentosin is adequate as a lube.
Date: Thu, 04 Sep 2003 06:44:52 -0700
Subject: Re: Help - The Bomb
From: Bernie Benz <b.benz at charter.net>
To: Richard Tanimura <richard at tanimuras.com>
Cc: 200q20V mailing list <200q20v at audifans.com>
>From: "Richard Tanimura" <richard at tanimuras.com>
>1. I have had to change one of the plugs 3 or 4 times in as many months.
>rubber O-ring seems to deform and then rupture causing G002000 to be
>liberally around the motor. An indication of when this is happening is that
>I hear a mechanical ticking from the servo pump - rpm dependent just like
>mechanical lifters. Anyone else see this deformation? What's the likely
The O-rings sealing the X cylinder heads are subjected to a rotary squeeze
when the head is screwed into place. If the O-ring is not well lubed with
EP grease or antisieze it may be stretched thin in some places and therefore
will be subject to failure at those thinned out places. Lube well when
installing, hyd fluid is not sufficient.
Use custom emotions -- try MSN Messenger 6.0!
More information about the 200q20v