pressure transducer swapping step-by-step?

auditude at auditude at
Tue Jan 27 23:39:35 EST 2004

Yeah, I'm thinking it probably isn't too bad.  Once I am ready I'll give it a shot.  Is this a 
solder wick type of a thing, or one of those vacuum bulbs?

What's with the extra surrounding leads that look like they are cut off shorter, flush with the 
body?  This is on a 3.0 bar PT if that makes a difference.  I have a 2.5 bar one coming, 
which will probably go in the 200q20v since it's otherwise stock.



On 28 Jan 2004 at 5:20, Richard Tanimura wrote:

> I've done it. It's a piece of cake. Desolder the 3 legs, pop in the new one.
> I would help if you can tell a good solder joint from a bad one though.
> Rich
> -----Original Message-----
> From: 200q20v-bounces at
> [mailto:200q20v-bounces at]On Behalf Of auditude at
> Sent: den 28 januari 2004 03:19
> To: 200q20V mailing list
> Subject: pressure transducer swapping step-by-step?
> Hi,
> Is there anything online as far as instructions for swapping the pressure
> transducer in the
> (Motronic) ECU?  It doesn't seem the actual procedure would be too
> difficult, but then again
> it's not something I want to take lightly.  I was thinking maybe there would
> be an online
> resource from someone who's BTDT?  Of course, if I'm not confident and
> comfortable about
> doing it I'll have a pro do it.
> Thanks,
> Ken

More information about the 200q20v mailing list