Euro Headlights

Kenneth Keith auditude at
Wed Apr 20 16:36:50 EDT 2005

Hey, on the headlight thing, my eurolights had one of the connectors
in the housing rotated 180 degrees.  Perhaps that's a cause for the
problem being seen?


"Derek Pulvino" <dbpulvino at> wrote:
> I'd have to agree with the poor relay setup as well...or are you sure you
> also connected the low beam input wire to the relayed harness in a solid
> manner?
> I find this somewhat interesting as I've had a similar problem on my car
> however very intermitently, and I'm using the harness from Blau.  The lights
> usually work fine, but I think three or four times, I've had my lights only
> work on the brites.  I know it's not corroded relays as I switched the
> relays around and problem happened again after that, nor is it a bad ground
> as there is a single common ground for the entire relayed wiring loom.
> In my case, the only other thing I could think of was a bad connection from
> the low beam wire in the factory loom to the low beam input on the relayed
> harness.  I haven't been able to kill my problem due to it's
> intermitance...whenever I get in to try and fix it, the problem has gone
> away.  So at this point things work fine through no effort on my part.
> Derek P

More information about the 200q20v mailing list