[V8] Re: 200 20V 2.4 bar readings

DasWolfen at aol.com DasWolfen at aol.com
Fri May 20 12:09:05 EDT 2005

In a message dated 5/20/05 11:31:24 A.M. Eastern Daylight Time,  
SuffolkD at aol.com writes:

Someone  mentioned the TAP set up could read more than 1.8 but I've never 
a  higher than 1.8/9 reading.............

 John J's RS2 converted 200q20v reads 2.0 bar max...even when the  boost 
gauge gets up around 28psi. I've personally never seen a 200 read higher  than 
2bar, I didn't even think the cluster processor was programmed to go  higher.

More information about the 200q20v mailing list