Parking Brake cables, R&R

Kneale Brownson kneale at
Tue Sep 20 19:41:27 EDT 2005

I've not actually pulled the cables off, but I had everything loose except
the brake lever end when I dropped the rear suspension to replace the fuel
tank.  Unless you're particularly adept with tools that angle, I don't see
how you'd get the lever end undone without removing the exhaust.  It looked
to me like it would be a struggle, but possibly doable with the driveshaft
in place.  I THINK it's just a matter of taking a nut  loose to let a yoke
relax pressure on the cable ends so they can be unhooked from the yoke.
There are some cable retainer fixtures at the points where the cables turn
toward the wheels.

At 01:21 PM 9/20/2005 -0700, Bernie Benz wrote:
>Anyone have words of wisdom for this project?  How does one disengage them
>from their anchor points at the actuating pivot?  Can this be done without
>R&R'ing the exhaust system and drive shaft?
>Thanks,  Bernie
>200q20v mailing list

More information about the 200q20v mailing list