coolant leak to timing belt job?

Ed Kellock ekellock at
Thu Aug 17 03:09:50 EDT 2006

Finally got back to this last night and tonight.  It's all back together and
running without leaks.
I retensioned the timing belt, replaced the small rubber portion of the
turbo coolant line, the short piece that feeds the heater core, the upper
and lower rad hoses and the thermostat.  
I also rewrapped the cable for the forward knock sensor, replaced the wire
connectors for the water gallery temp sensor/switch, and replaced the vacuum
hose to the fuel pressure regulator.
I refilled with distilled water and will flush it a couple times before
adding new coolant.  That should give me some time to gain more confidence.

-----Original Message-----
From: Ed Kellock [mailto:ekellock at] 
Sent: Wednesday, August 02, 2006 12:23 PM
To: Schaible, David
Cc: 200q20V mailing list
Subject: Re: coolant leak to timing belt job?

My premise is that the water pump leak is due to the loosening of its bolts
which would also explain the loose timing belt.  I did not have any untoward
noises from the area prior to noticing the leak.
If, when I attempt to adjust the belt tension with the w/p, I don't have
some confidence that that was the cause, I will re-examine my course of
action at that time.  If I do decide to dig further, i.e. remove the w/p for
inspection/replacement, I'll probably put a new belt on them too. 

More information about the 200q20v mailing list