trans removale

Kneale Brownson kneale at
Wed Dec 27 19:26:03 EST 2006

You have to push the cables up next to the sheetmetal with the tranny
pretty much mated to the engine before you can get it past the cables.

At 06:14 PM 12/27/2006 -0500, RicebalLDR at wrote:
>Hi I have slowly been pulling apart my 200 avant 20v to replace a failed 
>throw out bearing. I have the tranny moving to the rear but seem to be held 
>up by 
>the seat belt tension cables. I removed the side bracket but they seem to be 
>cought on the top of the trans. Do I need to go forward with the trans and 
>try to release the cables or is there something else beside the vertical 
>bracket on the side of the trans that needs to be removed? This project sure 
>a long time with only an hour or two a week to work on it!!!!!!!!!  Thanks 
>Richard Friedrich
>200q20v mailing list

More information about the 200q20v mailing list