Removel of glove box?

Kneale Brownson kneale at
Fri Jun 2 17:31:53 EDT 2006

Bentley says glovebox assemblies may vary.  Mine comes out with loosening
of two Alan head screws visible at the top inside of the box near the back.
 They're 4mm.  A standard 4mm Alan wrench can be manipulated to slip into
the screw heads, but cutting a quarter inch off the short arm allows for
easier insertion.  If I remember correctly, you just loosen them a couple
turns and you can slide the box sideways and out.  

At 04:20 PM 6/2/2006 -0400, Peter Schulz wrote:
>My recollection is at least four small philips head screws, two on 
>the left and two on the right side of the opened glove box.  The only 
>way to get at them was to buy a small bit socket wrench and use a 
>philips bit -no way to get a standard philips screwdriver in there....
>At 03:54 PM 6/2/2006, PeterBergin at wrote:
>>Was trying to work on my intermittent dash vents (AC on only problem),  Found
>>the re circulation flap is always closed, even in "LO" temp setting.   Spring
>>was good and box had a bunch of leaves in it.  However it will not  open when
>>I turn the AC temp way down and that's usually when I loose my dash  vents.
>>Got frustrated trying to remove the glove box and found the illustration in
>>the Bentley useless.

More information about the 200q20v mailing list