Loose steeri9ng wheel mount

motogo1 motogo1 at cox.net
Sun Sep 17 20:01:05 EDT 2006

I did. I could get it tight, but it would always come loose again. So I got
it tight and then drilled a small hole through the mount and inserted a
small nail as a pin. I'm sure an accident would break it loose. I also put a
little epoxy on where the two meet, but not sure how much that helps. End of

Gary Martin
94 UrS4
91 200 TQA

----- Original Message ----- 
From: "Chuck Pierce" <cpcycle at earthlink.net>
To: "Audi 200" <200q20v at www.audifans.com>
Sent: Sunday, September 17, 2006 2:30 PM
Subject: Loose steeri9ng wheel mount

> I replaced the ignition switch last year and in doing so I managed to
> knock loose the steering column from its mount in the dash. This mount
> has a bevel to swedge the steering column in place. The bevel allows the
> steering column to travel forward when in an accident collapsing the
> steering column. I have tried to use a clamp to swedge the pieces back
> together w/o any luck. Has any one had this problem? Or does anyone have
> an ideas on how  I can get it to stay tight? The steering wheel isn't
> going to go anywhere, but I would feel better if I did not have it
> rattling a small amount.
> Thanks
> Chuck Pierce
> 91 200 20v Avant
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v

More information about the 200q20v mailing list