Strut Braces, again!

Eric Huppert ehuppert at
Tue Apr 24 13:06:42 EDT 2007


Tower brackets are off of UR s4/S6. Not sure on the bar, but it does look
somewhat similar to the s6 bar

This type tower brace isn't going to correct weak towers (and corresponding
camber issues), you need a "jack-bolt" on the bar that will spread towers
back as needed. At one point in time Chuck Pierce (lister) had made a batch
of the center bars, but don't believe he's made anymore. I had expressed
some interest (no funds at the time though), as had some others, but guess
there wasn't enough takers to warrant making any more.

I'm probably going to get the tower brackets used and have a bar made. Guess
I need to do it soon as new tires just replaced the snows and my toe setting
is off a little bit due to previously replacing outer sway bar bushings and
one control arm.

cheers, Eric

More information about the 200q20v mailing list