[audi20v] Re: need to seal my water pump
b.benz at charter.net
Wed Jun 20 15:28:07 EDT 2007
On Jun 20, 2007, at 11:30 AM, Peter Schulz wrote:
> Clean/sand the block face so that the O ring can properly seal.
> Make sure that the O ring is in good condition.
> What may be happening is that when you are tensioning the Timing
> Belt by adjusting the water pump is that the O ring distorting on
> the block face.
The 0-ring needs to be lubricated, either with coolent, or in his
case, with Si caulk.
> I would avoid an epoxy repair at all cost.
More information about the 200q20v