91 200 trans seal

John S. Lagnese jlagnese at massed.net
Wed Feb 27 17:10:57 PST 2008

Is it uncommon for this seal to go? Is there any other potential points to 
check for a leak on that side of the tranny? Its a drip every couple of 
seconds when the gear oil level is high. Otherwise it drips while I'm 
----- Original Message ----- 
From: "Austin Calise" <stincalise at yahoo.com>
To: <200q20v at audifans.com>
Sent: Wednesday, February 27, 2008 12:33 AM
Subject: 91 200 trans seal

> Not spring loaded. Ok if your certain it's
> the axle flange seal........To remove the axle flange
> run a CV bolt in with a chisel behind the flange
> and it will pop out.(may have do this twice 180
> of the first bolt.) To remove the seal a pry bar
> or screw driver will work just be careful not to mar
> the machined surfaces. I've heard of using Curil T
> sealant to make sure cam style seals don't leak.
> http://www.pelicanparts.com/catalog/shopcart/9144/POR_9144_ENGmis_pg1.htm
> HTH's Austin
> ---------------------------------
> Be a better friend, newshound, and know-it-all with Yahoo! Mobile.  Try it 
> now.
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v 

More information about the 200q20v mailing list