rear wheel bearing

Kneale Brownson knealeski at
Sun Jun 8 09:32:36 PDT 2008

ETKA shows the same part number for fronts and rears except the rears have an "F" suffix.  The front kits I got from Autohausaz have the right part number of the box, but do not have any circlips.  They have an axle bolt and the bolt for the ball joint stem opening and a couple stop nuts.  Should I try some other supplier or can the OEM circlips be reused?

alancordeiro at wrote:  Kneale,

I did not know there was a difference between fronts and rears...I just had 
two kits from quite a while back, used them on the two rears...then when it 
came time to do the front wheels. I ordered two more kits....they looked 
identical to the previous, I do not recall any nylon inset nuts, there were 
two circlip washers and two axle bolts in each, the rears need two circlips, 
the fronts only need one.


----- Original Message ----- 
From: "Kneale Brownson" 
To: "Bernie Benz" 
Cc: "200q20V mailing list" <200q20v at>
Sent: Sunday, June 08, 2008 11:42 AM
Subject: Re: rear wheel bearing

Stop NUTS are those nuts with an insert in the threads that don't require a 
lock washer to keep them in place. You reuse axle bolts? They're all 
supposed to be one-time uses aren't they? They're supposed to stretch in 
the last 1/4 turn after reaching torque stretch, aren't they?

Bernie Benz wrote: No, What's a stop bolt?

On Jun 8, 2008, at 8:08 AM, Kneale Brownson wrote:

You've never replaced an axle bolt or a stop nut?

Bernie Benz wrote: Why the interest in the fasteners? 
I have / would never replace these


On Jun 8, 2008, at 6:09 AM, Kneale Brownson wrote:

> I know the front and rear wheel bearings are the same, but is the
> "kit" that includes replacement fasteners the sam

200q20v mailing list

200q20v mailing list 

More information about the 200q20v mailing list