PS Hose from rack to pump (Round 2)

PyRo pyro_10314 at
Sat Jun 28 12:43:57 PDT 2008

Ok so i had everything installed this morning. I started up my car and it was like the niagra falls were in my driveway. Is it possible that i tightened the banjo bolt to tight? It seems as if the geyser is coming from the back end of the new fitting (banjo bolt, hose, rack--the leak seems to be coming from the hose to rack area). I cant tell exactly cause its so damn tight in there. Could the pipe that travels along the rack be leaking, maybe? Could the new hose not be sitting flush on the rack, thus allowing it to leak?I already removed the hose twice and checked it. Both washers are in place. Could something be blocking the flow of fluid? Im just really stumped and slightly violent, and about to go take it off for the 3rd time today, so any suggestions would be helpful. 


More information about the 200q20v mailing list