PS Hose from rack to pump (Round 2)

Ed Kellock ekellock at
Sat Jun 28 14:09:06 PDT 2008

Did you lose an o-ring while navigating that end back into position?


> -----Original Message-----
> From: 200q20v-bounces at 
> [mailto:200q20v-bounces at] On Behalf Of PyRo
> Sent: Saturday, June 28, 2008 1:44 PM
> To: 200q20v at
> Subject: PS Hose from rack to pump (Round 2)
> Ok so i had everything installed this morning. I started up 
> my car and it was like the niagra falls were in my driveway. 
> Is it possible that i tightened the banjo bolt to tight? It 
> seems as if the geyser is coming from the back end of the new 
> fitting (banjo bolt, hose, rack--the leak seems to be coming 
> from the hose to rack area). I cant tell exactly cause its so 
> damn tight in there. Could the pipe that travels along the 
> rack be leaking, maybe? Could the new hose not be sitting 
> flush on the rack, thus allowing it to leak?I already removed 
> the hose twice and checked it. Both washers are in place. 
> Could something be blocking the flow of fluid? Im just really 
> stumped and slightly violent, and about to go take it off for 
> the 3rd time today, so any suggestions would be helpful. 
> thanks
>  danny
> _______________________________________________
> 200q20v mailing list
> No virus found in this incoming message.
> Checked by AVG. 
> Version: 8.0.101 / Virus Database: 270.4.2/1523 - Release 
> Date: 6/28/2008 7:00 AM

More information about the 200q20v mailing list