Hub Shark Users

kneale at kneale at
Mon Oct 27 15:31:18 PDT 2008

I'm preparing for my first use of a Hub Shark to replace a wheel bearing
on my 200q20vA.  I've removed the UFO caliper and the axle.  The Hub Shark
directions say to disconnect the lower control arm, but I presume that's
to make it possible to swing the bearing housing away from the axle so you
don't have to pull the axle.  Since I've already pulled the axle, is there
any reason to also disconnect the lower control arm?

More information about the 200q20v mailing list